O how i hate the new way i have to fiddle with track width :(
I really really are disgusted with the new way i must fiddle to change track widths , and even worse The new way gives errors without giving a clue what goes wrong. I wasplanning on keeping the old version but sadly that is not possible anymore. I really hate this new way of being forced to create design rules over and over For example i have a VCC track, which runs into a resistor .... next net, whick runs to the led next net and so on , every time the design rule adding a new rule getting errors that don't give any clarity. I was very fond of easyeda , but this is rapidly changing into frustration ... #PCB#
I don't like the new autorouting config , cumbersome, will downgrade right away
I like to play with trackwidths, just select a track and change the size on the fly to see if this changes the routing outcome. Now i need to edit / create a design rule every time i want a change, this is so much worse then just the click and go from the previous version. I hope you will consider reintergrating this into the routing config. Wil be downgrading now sine i really like the flexibility of the previous Routing config #FeatureRequests#
Unable to create a trace between 2 components , getting a circle with a cross
Hi Guys I really hope someone can help me out here , beem struggling most of the night to get this going , but i really am clueless. I am a newbie , so i'm learning on thefly, and i really don't care to being challenged. For this project i had to create a component (Which on it's own was challenging enough) there are 2 pads on the Card-edge PCB that i cannot get connected, one was a GND , (one of many, so i just disabled that one) The other one is D13 (pad 67) , i don't know if i made a mistake in designing the component, but it's strange that all others are working without a problem. I had a lot of problems with the autorouter, had to manualy adjust quite a few tracks to get it errorfree , except fot this one. i really hope someone can help me out on this .... off to bed , to catch at least 3-4 hours of sleep Nevermind , after struggling again for some hours, i finally did a reshuffle of all components on the board and now it renders okay .... #PCB#