asdasdasd
EasyEDA layout check, XLR boxheader to Hypex amplifier board
I did my first pcb design and although I think it is sort of correct I would love for some people with expreince to have a look. It has two XLR inputs at the top. And a box header at the bottom. The routing is correct that's not what I'm worried about. The issue is more the grounding, the thickness of the paths, the holes.. - The red paths are 25mil, is that good for audio (input audio from a pre amp before amplification)? - The grounding in blue I put on the back side because it crosses the signal paths. It's not the signal ground but just the case ground, I routed it to the screw holes. Makes sense? - The box header holes have 'solder mask expansion' set to 'general', seems to be 2mil, is that enough? Any other ideas and suggestions? #PCB#
raymond9 2025-07-09 20:36:10 comment 1 0 Circuit Design