asdasdasd
PCB Component Labels can't be moved after rotation
If I select a component label text (i.e. D1) and give it a rotation angle, then I can no longer move the label. I can still select it, and I get the move icon, but the text will not move. Setting the rotation back to zero does not solve the problem, and now I have several labels on my PCB that cannot be moved. This occurs with components as well. Once rotated (via the rotation attribute), they cannot be moved with the mouse. Fortunately, I can simply type a new location in the X location attribute. It is somewhat annoying though. I'm using the Windows 10 client V6.2.46 Thanks -- Bob P.S. I found a really cool feature where you can press alt to change the snap if you set it up properly on the Canvas Attributes. I like it alot but sometimes when I am using it, it kills the menu Easy EDA Std, file folder, undo, etc. The whole top row disappears. I'm sure its intentional, but I can't figure out what key combination causes it and I can't restore it. I have to use CTRL-S to save and then restart the application to get it back! #BugReports#
rbroders 2019-10-22 12:06:55 comment 2 0 Bug Reports
Green pads???
I added a trimmer to my circuit and two of its three pads are green! Also when I connect it to my IC, the trace and the IC pad turn green also? No DRC errors. What gives? Why? Curious -- Bob #PCB#
rbroders 2019-10-11 13:22:36 comment 9 0 Circuit Design
VIA in a pad?
I'm trying to layout a high current switch. I am using 2oz copper and have copper areas directly bonded to the Drain and Source of my MOSFET. Unfortunately I have been having trouble getting good solder joints. To increase my chances for the next attemp I am bending the legs to give myself more room to solder, and I created some gigantic pads so I can heat them up with a 130mil soldering iron tip. I also thought to heat both top and bottom it would be good to put some vias in the pad so the heat will transfer and I can get a good solder joint without shorting anything. However I keep getting DRC clearance errors. Of course the vias and the pads are on the same NET, but the error says they are not. Any ideas? Thanks -- Bob P.S. When soldering (from the bottom) the MOSFET legs heat up first and solder runs through the holes down the legs and builds up on the bottom of the MOSFET until it bridges legs (all without sticking to the pads). I have tried to mitigate this as well by reducing the size of the holes a bit and converting them to slots... #PCB#
rbroders 2019-09-27 14:55:19 comment 2 0 Circuit Design