from datasheet to s parameter
hello all, Typically, we use the impedance data shown on the datasheet to create an s-parameter file (.s1p, .s2p, etc.) for each port of the mixer. These files can be used to simulate the impedance matching. but, how can we achieve above goal with ADS ? I have following data sheet. #Schematic#
how to get these values?
hello, i am using LT5560 right now. i try to design the match circuit. from the instruction of LT5560, i get the following table. i want to get the imput impedance for frequency at 910MHz, but this frequency does not show up in the following table. i wonder how to get this value? #Schematic#
how to know specific parameters of a module found in easyeda library?
hello all, i am a freshman for pcb design. I want to have a local oscillator which can produce carrier frequency around 900MHz. so, i search oscillator in easyeda library. and, i find the following oscillator: but, i do not know whether this one can produce carrier frequency around 900MHz that i expect. i don't know how to check it. it seems that it is from kicad library. thanks all for helping me to figure it out. #Schematic#
cannot get expe cted result
hello, I design a piece of circuit in the following first image in easyeda for simulation. the purpose is that i just want to get 72Khz signals from power line (AC power with 220-110v 60hz) but when i simulate is with AC analysis , i get the following second image. so sad, .... actually, i want to get the following third image. hope some one can help me. i am a freshman to do this. #Simulation#
how to probe voltage in simulation
i am using voltage probe. but it always gives me db. how can i get the voltage? even though i use probe V(netname). it still gives me db rather than voltage #Simulation#