Unable to save PCB - "Bulk write failed... too large for the cluster..."
I am getting this on a project when I attempt to save the PCB. Is this a product limitation, or a bug of some sort? Thanks. #PCB#
Auto router with failed connections, but no ratlines to locate issue
I have a project where the auto router is unable to complete all connections. I am trying to locate the root cause of the issue. Normally, I view ratlines to find the failed connections. In this project, I see no ratlines after the routing failure. How can I get more details on the failed connections? Thank you! #PCB#
Local auto router - Increase number of processor threads and/or usage?
Any tips for increasing the number of threads (and/or processor usage) used by the local auto router? My CPU sits mostly idle during auto routing. I am running a Ryzen 9 5950X with 128 GB of RAM. Thanks! #GeneralDiscuss#
Import Changes to PCB now really slow
I notice with the latest version that Import Changes from the schematic to the PCB layout is extremely slow for me. Are others seeing similar behavior? #PCB#
Recommended approach for building daughter boards (physical alignment) and combining PCBs?
A two-part question... 1) I am looking to have a design with a base PCB that takes a daughter board, connected with pin headers (~30 pins). Are there recommended approaches for creating the layout of the base PCB and then bringing the exact dimensions over to a daughter board? For example, can I copy the pin headers from one PCB and paste them on another, and then associated them with the relevant items on the daughter board schematic? 2) If I have multiple, separate schematics with PCBs that I would like to combine into a single PCB, I know that I can copy the schematics. Is there also a way to copy the PCB elements, in their layout, without having to rebuild the entire PCB layout off of the updated, consolidated schematic? Thank you! #PCB#
[Update PCB: Import Changes] never completes and PCB editor extremely slow when using more than 2 layers and an inner layer set to 'plane.'
I have a project where I have made changes to the schematic and am trying to update the PCB (Design\Update PCB). I get an "Import Changes" progress bar, and it essentially gets stuck between 60% and 80%. I have left it running for hours, and it never completes. I am using the latest desktop version on Windows. I have tried it from three different PCs. Is there a current service issue causing this? Suggestions on how to resolve the issue? Thank you! Update: I am using a four-layer stack with a GND inner plane. Reverting to two layers or using only 'signal' for inner layers restores performance. Having an inner layer set to plane causes the issue. #BugReports#