asdasdasd
Auto Router problems in current version
With the current version no new PCB with Auto Router finishes. Older PCB routed from 2019 or spring 2020 does very well also with the new version. The current PCB 2 layer routing has no Vias. This is possibly the failure. But even a simple 1 layer PCB doesn't get finished. Stuck with 50-60% I use the local router 0.8.11, still current version since Autumn 2019. Do only I have this problem ? If there is a known issue, Which? What I should deliver to solve the problem ? ------------------------- Solved: in the EasyEDA:: Tools --> Set Board Outline It took me 1 week of checking, comparing with old versions, find out what is the difference and so on. Then i read in the release notes that you chaged something with the outline editing. and i read the following comment: https://easyeda.com/forum/topic/Autorouter-not-working-after-last-update-d53263b0ce0147e099dbc2c476b77a91 andyfierman and another remarkable guy recommend to reset the board outlineThank you. #PCB#
ritzeng 2021-03-21 15:33:23 comment 2 0 Circuit Design
4 Layer PCB, but Layers aren't really all perfectly used
Autorouter since days didn't finish my route. But it is simple to do so. So I fixed 2 missing tracks manually. The Problem here is the ATMEGA328P series of VCC - GND - VCC - GND following pins no 3 to 6. I filled it manually as follows: I tried hours with small rearrangements if parts to hope that the router did it self. I think such pattern should be detected and handled properly. I also fixed the processors manual tracks and hoped that autorouter does the rest, but no, he rearranges around in an awful manner. Means, if you have added something manually then you must finish manually. There seems no detection to accept some existing tracks in reusing them. In general I found out that the 4th layer isn't really efficiently used. But when I pay for 4 layers, all layers should be used without prioritizing the layers 1 and 2. These are requirements, not bugs. best regards Frank #PCB#
ritzeng 2019-04-23 20:32:13 comment 1 0 Circuit Design
Adding new Components place component in the double size of the old ones
Hello when i open my old schematic and add now a new component it appears in the double size. Old schematic has to boxes between 2 pins. The new component has 4 boxes between pins. Can you please help me how i can add the components as it was weeks ago ? Best regards Frank #Schematic#
ritzeng 2019-03-22 02:49:00 comment 1 0 Circuit Design