asdasdasd
multible copies of a reuse block
hi I've already searched, but I haven't found a satisfactory answer. I would like to insert several copies of a reuse block into a schematic. Of course that works. However, when I do the drc check I get the error message that some ports are short-circuited. That's also ok because there are power pins that are all connected to the same network. Why do I get an error message? How can I get around this? Of course I don't want to get any error messages and I want to be sure that everything is ok. It's enough for me that I get a lot of warnings: ([Warn]: Component attributes does not match the Supplier Part, It is recommended to use Device Standardization) even though I only placed components from LCSC electronic. Can someone help me. that's a bit annoying. Greetings Uli #Schematic#
ruesti2 2025-03-05 06:34:16 comment 1 0 Circuit Design