asdasdasd
importing changes affects components that haven't been modified
Hi, I made a small change, where I changed the connections on my mosfet, which was the wrong way around. When I went into the PCB layout to import changes, it listed a whole bunch of components changes (which there was none other than the small change I mentioned). Then it proceeded to get me to replace all my components again, which is definately far from ideal. Can you please advise what I should do to simply update this small change, without having to rebuild the board again. Thanks, Sam #PCB#
samtylee 2022-03-19 19:00:01 comment 3 0 Circuit Design
How to add heat sink
Hi, I would like to add a heat sink (e.g. C116600) for my LT3652 IC on the underside of the PCB board. When I add the heat sink to the schematic, and then the layout, it is shown with an incorrect rotation. Also, I am unsure how I can actually place the component on the board. I am not sure if I need to add an exposed copper area or not, and how to do it. Also assuming if it's a through hole heat sink, a silicon pad is not needed? Thanks, Sam #PCB#
samtylee 2021-12-05 23:35:42 comment 6 0 Circuit Design
Importing LT spice ASC files for simulation
Hi is there a way to import LTspice files into EasyEDA for simulation? For example the following file? https://www.analog.com/media/en/simulation-models/LTspice-demo-circuits/LT3652_TA04.asc #Simulation#
samtylee 2021-07-22 15:15:33 comment 1 0 Circuit Design