asdasdasd
Spice Netlist too big error
I have a pretty small circuit (1 op-amp and 6 discrete components). I'm trying to run a simulation, but I'm getting an error that my net list is too big. What should I do? You can see my circuit here: https://easyeda.com/editor#id=yJDxPJ1jB#Schematic#
scott216 2014-05-01 11:02:13 comment 7 0 Circuit Design
How to create AC voltage source
I can't figure out how to create an AC voltage source. Is there someplace that documents the syntax. I want a 60 Hz sine wave from -12 v to + 12 volts. I tried SIN(-12 +12 60) but I get 0 to -24 volt sine wave. #Schematic#
scott216 2014-04-28 17:32:01 comment 15 0 Circuit Design
How to format code in this forum
I wanted to post some code in this forum, but I'm having trouble formatting it. First I indented by 4 spaces, then clicked preview, but that didn't work. Then I tried the markdown viewer. I added after each line, but in preview it ignored it. I ended up just adding a blank line between each line of code. What's the right way to format in this forum? I hope you consider using different forum software for EasyEDA. I don't think this one is very good, especially if you start getting a real community on here. Simple Machines seems like a good one; EEVBlog uses it. #Schematic#
scott216 2014-04-26 06:39:11 comment 5 0 Circuit Design
Change project from private to public
Can I change my project from private to public? If so, how. #Schematic#
scott216 2014-04-25 12:05:33 comment 1 0 Circuit Design
How to get into select mode
After I draw a wire in my schematic I can't get out of that mode. I keep getting the red cross-hairs. I want to go into a select mode so I can click on parts and move or delete them. I tried escape key, but that doesn't work. I'm using Firefox browser. #Schematic#
scott216 2014-04-24 06:54:33 comment 1 0 Circuit Design