asdasdasd
Improper Copper Area pour
In my 2-layer PCB design, I faced an issue where the GND copper pour did not fill around the STEP, DIR, and EN signal traces near the stepper motor driver headers (M1/M2). Even though: All GND nets were properly connected in the schematic Copper pour was assigned to the GND net GND poured correctly in other parts of the board The area around the stepper signal traces remained unfilled when "Keep Island" was set to No. #PCB#
shavali shaikh 2025-07-01 19:52:48 comment 8 1 Circuit Design