asdasdasd
Formal definition of the "Document Layer", please
You all have been so helpful these past few days and my project is almost ready for fabrication order. I have another question though, and this has to do with the "Document Layer". I tried to find a mention of it using search, but only references to it by others... so... i just want to be sure because i am using it to mask out a part's outline. Would it be correct to say that if a PCB layout has things in the "Document Layer", that they will not be printed on the actual circuit board? Thanks again :) #PCB#
sinelari 2016-04-27 00:17:42 comment 5 0 Circuit Design
Pads with holes on single layer do not show holes in photo mode
Hi! :) I have 3 types of pads for my double sided PCB. I will be mounting parts on both sides. All parts are through-hole parts. One side, the top layer, has room for only LED's. The other side, the bottom layer, will be mounting several resistors. I am using 3 types of pads; top, bottom and all-layers. The DRC shows no errors on the layout. When looking at photo mode, only the holes that are "all layers" show up with holes on both sides. The holes for the other two types only show up on one side of the board. I want every hole to go through the board. Photo of both sides are below. Notice the tiny hole on the top for a via. Notice the pad next to it on the bottom side layer with the green arrow pointing to it. Notice on the top view of the board, that hole does not exist. That is only one example. There are approximately 50 other holes that are missing. Am i doing something incorrectly, or is this an error in the software? #PCB#
sinelari 2016-04-26 18:05:26 comment 8 0 Circuit Design
Difference between pad, via, and hole
I am including a picture of a PC Board with an LED mounted into it. It is not possible to solder an LED onto the surface it is mounted. It is only possible to solder an LED from the lower surface. The graphic depicts an LED with copper lands. Is there any connection between a pad from the top to the bottom using "All levels"? If so, please tell me how it is accomplished. Is it lined with copper? Does it use an inset sleeve? Does it use brads? In the past, i have worked with multiple level boards of all types. Some use wires from the bottom with no copper on top and connect over the top of the board using wire. Others use a pit-brad that is pressed into the PCB after it is drilled. But also there are boards that require both sides to be soldered and use the lead on the part-package to provide electrical connection. I intend to order my PCB from you at EasyEDA. Tell me, please, how you accomplish the electrical connection with pads, vias, and holes. Are they all the same or are they different? Thank you. #PCB#
sinelari 2016-04-26 07:42:59 comment 12 0 Circuit Design
2 features requested, please.
Independent X and Y settings for both grid and snap Many of my parts are circular rather than square and the boards i work with typically fit into tubes rather than boxes. The math to determine how many squares of a particular size fit into a square box with a square board is simple. Try the same trick with circles on a circular board and you will see why independent axis would be helpful. Circular tool for PCB Board Outline Layer This would be more intuitive than connecting two arcs after working the math to center them. To achieve the number of parts a particular board would hold before designing the schematic to drive them would be an engineering plus! This one step would save a lot of time, but it was fun trying to do it. Yes, i pressed "Save". :) Hope this helps #FeatureRequests#
sinelari 2016-04-24 02:07:12 comment 18 0 Feature Requests