Why does my measure statement fail?
Could someone, please, help me understand why the measure statement in my schematic fails? The link to the project is: https://easyeda.com/editor#id=|83a3d312c3bf41a6adb1b88930832a30 #Simulation#
New to EasyEDA and getting unexpected simulation results.
I'm new to EasyEDA. I'm trying to simulate a differential amplifier and I've placed a voltage probe at the output of the op-amp but the results I'm getting are not as expected. The simulation shows a waveform with an amplitude of almost 200V while the op-amp is operating with a supply voltage of 3.3V. Clearly this cannot be. Where am I going wrong? The link to the project is https://easyeda.com/spiffer00/differential-amplifier-01 Thanks. #Simulation#