asdasdasd
M3 Flathead screw hole
Is it possible to define a screw hole in the PCB that is countersink for a M3 screw? #GeneralDiscuss#
terry8345 2022-06-30 19:48:07 comment 1 0 Others
Inner layers to "planes"
If I select a 4 layer board and make the two inner layers "planes", the editor will freeze when I attempt to move a part. It usually takes a few minutes for the part to be moved. This is totally unworkable. It would take weeks to layout a board. If I change the inner layers back to "signal", then the editor works fine. #PCB#
terry8345 2022-02-15 08:48:58 comment 2 0 Circuit Design
EasyEDA Performance
For the past week or so, EasyEDA has been running very slow in PCB Layout. Schematic capture seems to work fine. It takes forever just to move a part on the PCB. Usually a minute or more. routing is also very slow and I have to wait for a few seconds when routing a net for it to complete. I'm using the online version. The Desktop Client version also does the same thing. I'm pretty sure it's not my computer. I'm not having issues with any other application. I don't think it's the browser (I'm using Firefox) because the Desktop Client version does the same thing. Anyone else having these same problems? #GeneralDiscuss#
terry8345 2022-02-11 00:32:44 comment 11 0 Others
Hot Keys for Inner Layers
You can type "T" or "B" to switch layers to top or bottom layers when routing a board. What are the hot keys for switching to inner layers, say for a 6-layer board. #PCB#
terry8345 2022-02-09 05:45:42 comment 3 0 Circuit Design
Via default properties
Is there a way to set the default hole side for a via, so I don't have to keep changing it after I place it on the PCB? I can't find any menu for setting default values except for DRC. The minimum hole size for a via is 13mil. When I place a via it is set for 12mil, which gives a DRC error. I would like the default value to be 13mil. Is it possible to change it to that? #PCB#
terry8345 2017-05-25 23:37:22 comment 8 0 Circuit Design
Connecting to Inner Plane (Power Plane)
I have defined Inner1 as a 5V power plane and Inner2 as a Ground Plane. I have several SIP packages (1x8,1x10 etc.) on my PCB. Some of the pins on the SIP packages are connected to Ground and 5V. How do I connect those pins to the inner power planes? This is the first design of mine using EasyEDA and the learning curve is difficult with this software. I find it hard to find what I'm looking for in the documentation. I'm used to using ExpressPCB's software and it is a very different concept than this software. Regards #PCB#
terry8345 2017-02-28 21:33:52 comment 1 0 Circuit Design