Copper area does not respect clearance on some pads
Hello, I have a problem with a footprint (contributed footprint, but I have made it again from scratch and the problem is the same). On some pads, when I add a copper area, the copper area does not respect the clearance around some pads. You can see the problem on this design : https://easyeda.com/tgrauss/hifi-control . Please look at the SDA pin of the CPUU1 component. This pin is the SDA I2C line, but the copper area fill it with GND. Of course there is a DRC error because of this problem. It is doing the same on some other pins of CPUU1 if I add a copper area on the bottom side. How can I solve this ? Thank you #BugReports#