asdasdasd
HALF74HC112EE
https://easyeda.com/editor#id=V1Vd60Kuo|laGYSM4AS|Dd7pjBgas|4eA9XxFXL|d1Vd7pjBT|YP13b9gCu|LjXi6wuit Hello all together, I want to simulate a Phase-detection with two HALF74HC112EE circuits. But in this manner they do not work. Only one circuit works!!! Please tell me what I am doing wrong!!! Many thanks in advance. thomasx the german #Simulation#
thomasx 2016-08-06 06:42:12 comment 1 0 Circuit Design
Trouble with HEF4060BEE
Hello to all, Today I have a question about the subckt HEF4060BEE_TEMP. This one is listed in the list off all avaiable subckts. I try to simulate a oscillator circuit, but it doesn't work. Is it ok to use this subckt??? many thanks for your advice and many greatings from Germany to all!! Update: ++++++++ The same problem occurred with the DLATCHHEE subckt!! Kind regards thomasx #Simulation#
thomasx 2016-08-05 11:43:52 comment 10 0 Circuit Design
ADC modells
Hallo alltogether, Are there any ADC models in the library avaiable??? Many thanks for your replies. Regards thomasx #Schematic#
thomasx 2016-07-30 14:22:35 comment 2 0 Circuit Design
Error message by Simulation: doAnalyses: out of memory
Hello community, starting the Simulation i get the following error message: doAnalyses: out of Memory. Can anybody gives me some Infos what's going wrong. What can I do to avoid such a error?? I very much apologize for my bad english!!! I know "My English is a little rusty" I can promise significant improvements!! Many thanks! Best wishes, thomasx #PCB#
thomasx 2016-07-22 14:18:39 comment 2 0 Circuit Design
Trouble with Logic subcircuits
Hy all together, today I try to create a circuit with some logic subcircuit. I take a JKMSFF out from the standart lib. But I have the error message unkown subcircuit! What's going wrong? I think in this library shown left Hand side, I can get this one!! Many thanks in advance for your friendly help #Simulation#
thomasx 2016-07-19 17:22:27 comment 4 0 Circuit Design
Max. simulation time exceed! Try it another day
Hello all together, I'm an newbie in using EasyEDA. Now I get the error-message above. What is in detail the reason to get this message? To avoid this problem in future, what have i to do? Many thanks for all kindly help. Thomas the german #Simulation#
thomasx 2016-07-10 08:04:24 comment 3 0 Circuit Design