asdasdasd
Driving high current using op amp (OPA539)
Hello everyone, I was wondering if anyone had a suggestion for how I may drive 3 A of current through a load using the high current op amp OPA539. Link to circuit below. https://easyeda.com/editor#id=42ccd8becba349dba7949c16eac996eb I want my Vin (Vard) to control a current going through my load (R1 in the circuit, which is going to be 4 ohms), and the max current I want to drive through this load is 3 A (therefore in theory should only need 12 V on the op amp output). I can manage to get a total of 1 A flowing through R1 when the load is 25 ohm, but as soon as I decrease this resistance to my target of 4 ohm the circuit breaks down and everything goes a bit wrong. Adding more voltage to the V+/V- (Vp/Vn) or Vin (Vard) seems to do nothing to help either. I have tried many different resistor configurations around the Vout and inverting input but nothing allows me to get more than 1 A through R1. The op amp is a high current op amp which should be able to drive up to 7 A. Does anyone know if this is a limit of the simulation (definitely not a limit of the power source (have tested this)), or have any ideas of how to make this work?? Thanks in advance, Tim #GeneralDiscuss#
tim04444 2017-05-02 18:13:24 comment 4 0 Others
Simulation error (too big) despite no obvious error
Hello, Has anyone come across the problem where the error 'Simulation is too long, maybe your schematic is too complex' ?? Link below https://easyeda.com/editor#id=03afa194766b4d33aa1b61e6e001d447 The error box suggests to make the simulation less complex, not so long, less probes, etc. This cannot be the reason though because the error repeatedly returns even on very simple circuits (I tested a simulation using a circuit consisting of only a power source, resistor and ground). I have also tried the simulation mode on circuits previously working, and still the simulations does not run. I thought it may be the fact that I had run out of simulations for the current 24 hours (yesterday), but this has now reset and the new error message (simulation too long) only appeared after this (today). Any help would be very much appreciated - was looking forward to the reset ending and being to run the simulation again. Regards, Tim #Schematic#
tim04444 2017-05-01 00:20:12 comment 2 0 Circuit Design
Help needed with simple op amp simulation problem
Hello everyone, I am new to analysing circuits using a simulator and am stuck, and was hoping if someone could possibly help me. I have made a simple op amp circuit where the gain is x2 for the voltage on the non-inverting input. What I am struggling with is getting the correct read-out for my voltage output. In the simulation (link bottom of message), you will see that I have added two voltage probes, one on the non-inverting input (V1) and the other on the output of the op amp (V2). V1 GIVES ME 5 V as expected, but V2 gives me 0 V where I expected to get 10 V. Could someone please help me and tell me if I am missing something. Is it something specific to using an op amp in a simulation, or maybe have I used my V+ (+15 V) and V- (-15 mV) incorrectly? Apologies if this problem is very simple and has a very quick fix that I am missing. I have read the handbook a couple of times and am struggling to find the answer myself. Thanks in advance. Tim https://easyeda.com/editor#id=29be4309ca5d4b3987f94987a834f051 #GeneralDiscuss#
tim04444 2017-04-26 17:58:59 comment 3 0 Others