Problem with placing OP amp
Since the update the placing of double or quad opamps does not work as before. The program does not set the right designators so instead of U2.1 and U2.2 it sets U2.1 and U3.1 which leads to the placing of two footprits on the PCB. I tried my own library parts that worked before and direct parts from LCSC library, both the same issue. HELP PLEASE! #BugReports#
Separate clearance setting for holes
I would like to suggest to add a separate clearance setting under 'Hole Properties'. If i use the PCB Tool the clearence to a copper plane is set by the general clearance which in many cases is to small if you are using washer and nuts which could lead to a short.when assembling the pcb to a case. Right now i use custom symbol and footprint with NoSolid copper areas included as discussed in the pcb layout section of the forum. Example: https://easyeda.com/tubes3000/forum_example Thanks, Olaf #FeatureRequests#
Separate clearance setting for holes?
Hi, Is it possible to set the clearance for holes independently from the general copper clearance? I want to have the copper plane free where the hole is if the pcb is mounted with washers and steel screws to prevent a short to the chassis. So far i made separate round copper areas with set to NoSolid but this is a pain in the butt. It would be nice to have a setting option in the hole attributes so one could set it for every diameter possible. Does somebody has an easier solution or is it possible to put it in the future feature list? Cheers, Olaf https://easyeda.com/tubes3000/forum_example #PCB#
Pre setting for Canvas Attributes
Hi, is it possible to set the canvas attributes in advance so when creating a new pcb the attributes are already set the way i want them to be? Haven't found an answer anywhere yet. #PCB#