asdasdasd
Why do trace outlines show inside pads?
Why do traces show on pads in the 3D view when they are part of the same net? Shouldn't they be a single connected piece of copper? #PCB#
victorsuciu 2023-01-28 23:04:30 comment 1 0 Circuit Design
3D chunk of metal
I am designing a very simple bipolar EMG probe. Currently each electrode is an exposed region of copper. Is it possible to instead have a solid chunk of metal like stainless steel that extends past the board surface? Here's a picture of what I have so far and what I am trying to do: #PCB#
victorsuciu 2023-01-19 19:21:14 comment 6 0 Circuit Design
Preventing pin and mounting holes from going all the way through the board
I'm an electronics noob so sorry if this is a dumb question. I am designing a very simple bipolar EMG probe. It consists of three copper electrodes on the bottom, each wired to a 3.5mm headphone jack on top. I'm planning to connect it to an off-the-shelf EMG amp like the Grove EMG detector or the OYMotion Gravity EMG sensor. Here's a picture: As you can see, the headphone jack's mounting holes go all the way through the entire board including the electrodes, reducing their contact area. The headphone jack (PJ-621C) has extremely tiny pins that do not extend below the component body so I don't see why it needs to penetrate 3 whole layers of fiberglass on this 4-layer board. Is it possible to stop drilling the holes before reaching the bottom layer? Even better, would that be possible on a 2-layer board with only a single sheet of fiberglass? I did find this post about vias that said only through-holes were supported and blind vias were not, but that was only about vias and it's a 5-year-old post. Thank you #PCB#
victorsuciu 2023-01-18 09:12:38 comment 2 0 Circuit Design