asdasdasd
What is it? Pad or track & how to connect?
Hello Can anyone please suggest as shown in image that how to make capacitor tracks or pads in easyeda? is it a pad or track and how to create it? Please support if anyone has done it earlier. Thanks in advance for support. #GeneralDiscuss#
vikramnain20 2022-05-20 02:51:15 comment 7 0 Others
Ratline error for ground net.
Hello Andy Iam getting error for ratline showed in pcb layout image as attached.I tried to make nos. of GND vias but its not getting connected. Thanks for your support in advance. Its on the right side of PCB named - S1 Chip which is not connecting to gnd even after created many vias. #PCB#
vikramnain20 2021-08-26 23:16:05 comment 1 0 Circuit Design
Schematic issues or bug
Hi Andy Find the issues i found in the schematic capture when i convert the schematic to PCB and returns to schematic then it all show the broken connections. Attached here the image for same. Need for your support. Thanks in advance. #Schematic#
vikramnain20 2020-12-28 18:22:00 comment 9 0 Circuit Design
Snap or component connection error in Schematis.
Hi I have tried all the way to solve this issue to coonect to components to the module. It doesnot connect at all, tried all snap scenarios. Can you plz look into my schematics and suggest me the way to come out of this? Thanks in advance for your support. Below is the link of my project.. https://easyeda.com/editor#id=|b4e4e369a3394342943705df87c665fa|4f8aa0e6b4444c9c989dd7abe2e45890 #Schematic#
vikramnain20 2020-10-14 22:03:40 comment 1 0 Circuit Design
Multinetlabel issues in PCB Layout
Hello It would be nice if someone help me on the below issues i am getting in PCB Layout. I have connected multinetlabels in my schematics and when iam doing the layout netlabels are not showed connected to the controller and connected to the netlabels only. just for examlpe-- capacitor c1 & c2 is connected to 3.3vd,gnd & microcontroller on 23 & 146 pin nos. in schematics. But when i layout the PCB found that 23 & 146 pin nos. shown 3.3vd written on it. and c1 & c2 shown connected to 3.3vd & gnd only. Should i connect it to controller pins 23 & 146 also or it will automatically connect it. just chk the image and help me on it. I will appreciate your help.My circuit is connected with multilabels. #PCB#
vikramnain20 2020-09-14 02:49:08 comment 8 0 Circuit Design
incomplete nets error
Hi Iam getting contonuous error on incomplete nets. Can anybody support me on this? attached is the link for project thanks in advance magnetometer #Schematic#
vikramnain20 2020-02-07 16:49:23 comment 7 0 Circuit Design