asdasdasd
Ratlines NOT UPDATED IN REAL TIME
Good morning how are you? I have a serious problem. When I make a connection between some PADs, the Ratlines insist the connection was not made! (as in the picture below). I already created another scheme and the error remained! Also note that if you save and reload a page, the Ratlines will already be disabled (which is correct since the links in those points have already been made); however, when making the other link among other components, these Ratlines reappear! I have to deliver a project tomorrow! Please help me! #BugReports#
viniciusmay 2018-05-22 14:06:15 comment 21 0 Bug Reports
Multiples Inner board outline cut-out
Good morning everyone! I am new to the forum but I have experience with the development of PCB (cad Eagle). Recently I discovered the EASY-EDA platform and started to study the platform. I'm developing a circular PCB that has internal slits (2 arched slits). And when I create the copper area, the following message appears on the display: "EasyEDA does not allow inner board outlines cut-out, please use SOlidRegion or HOLE". The point is that I used the Board-Outiline layer to draw the intended traits; because previously, when I used the Top layer, when clicking on the previous PCB preview, the features were not really 'pierced' - the demarcated site was only copper free. Can anybody help me? I have urgency in this delivery! #PCB#
viniciusmay 2017-11-12 14:38:22 comment 15 0 Circuit Design