asdasdasd
EasyEDA PRO component substitution
How to substitute a component without riping up the PCB? There is a find and Replace (CTRL-F) in Schematic but it doesn't work. The substitude part is the same size, an 0603 resistor. The only way that I can now is to delete the part in schmeatic then put the sunstitute part in. This tedious process will rip the part out the layout and you will need to place it all over again. When you have 20 parts (resistors in this case) this becomes very tedious. This is a VERY important function EASYEDA should abolutely have. Thank you #Schematic#
wiprobe 2024-10-11 02:42:36 comment 1 0 Circuit Design