the netlist from easyeda can not use in ngspice
I use easyeda and create a schematic,and then run. I get the netlist. I save the netlist in local file called test.cir.Then I use ngspice to run test.cir in command line, it result error. the ngspice result is: Circuit: new schematic Doing analysis at TEMP = 27.000000 and TNOM = 27.000000 Initial Transient Solution Node Voltage xvm1_1 0 +5v 0 vxa1#branch 9.52495e-047 No. of Data Rows : 1008 probe: no such command available in ngspice Note: No ".plot", ".print", or ".fourier" lines; no simulations run the netlist as following: Untitled XS1 XVM1_1 GND SPST_ON VXA1 +5V GND 0v D1 +5V GND LED .param pi = 3.141593 .func LIMIT(x, y, z) {min(max(x, min(y, z)), max(z, y))} .func PWR(x,a) {(MAX(ABS(x), 1e-313))*a} .func PWRS(x,a) {sgn(x) PWR(x,a)} .func stp(x) {u(x)} .func log10(x) {ln(x)/ln(10)} .func SQRT(x) {(MAX(x, 1e-313))*0.5} .func INT(x) {sgn(x)floor(ABS(x))} .func URAMP(x) {max(x,0)} .func POW(x,a) {(((a-(int(a)))==0)||(sgn(x)>=0))( max(exp(ln(uramp(x))a),0) + (2(0.5-ABS((int(a))-2int(a/2))))max(exp(ln(uramp(-1x))*a),0) )} a res with very small value .subckt SPST_ON 1 2 r 1 2 2u .ENDS .MODEL LED D IS=661.43E-24 N=1.6455 RS=4.8592 .control tran 1u 1m 0 probe V(XVM1_1)-V(+5V) I(VXA1) quit .endc .END my project address is https://easyeda.com/editor#id=Fr0YI4cWi#General Discuss#