PCB Design Feedback Request: ESP32, SIM808, and Sensor Integration

Hello everyone,

I'm working on a 4-layer PCB design and would appreciate any feedback or recommendations you might have. Here are some key details of the design:
 Microcontroller: ESP32-C3FH4 for control and communication
 GPS/GPRS Module: SIM808, with SIM card support
 Sensors:
• MLX90614 for temperature measurement
• MPU-9250 for acceleration sensing
• APDS-9960 for proximity detection
 Power Management: TP4056 module for LiPo battery charging and seamless switching between USB, battery, and external power
 Antenna Connections: Separate GSM and GPS antennas for the SIM808

 Layer Configuration:

 4-Layer Stack:
• Top Layer: Signal
• Inner Layer 1 : Power
• Inner Layer 2 : Ground
• Bottom Layer : Signal

 Design Goals and Specific Areas for Feedback:

1. Power Supply Stability: I'm particularly concerned about ensuring stable power to the SIM808 module. The power circuit includes components for USB/battery power switching. Any suggestions on component selection, layout, or decoupling for power stability?
2. Power Consumption Optimization: I'm exploring power-saving features such as ESP32 deep sleep. Would love advice on component adjustments or layout techniques to reduce overall consumption.
3. I2C Communication Reliability: This design involves multiple I2C devices connected to the ESP32-C3. Feedback on pull-up resistor values or tips for improving I2C communication stability would be very helpful.
4. Antenna Placement and Routing: Since I have GSM and GPS antennas for the SIM808, I want to ensure optimal placement and minimal interference. Any best practices on antenna layout, ground plane isolation, or signal routing?

I've attached the schematic and PCB layout below. Looking forward to any insights you can provide to help make this design more robust and efficient.

Thanks in advance for your help! Schémtic

Top Layer and Bottom Layer

inner 1 and inner 2

#PCB#
Circuit Design
Multiple components to one footprint

I've read a few posts about this topic though I still cannot achieve what I want. I created a very simple nonsence schematic to  illustrate the issue:

https://oshwlab.com/lipchansky/new-project_2024-10-24_22-11-21

V1.1, V1.2 - two halves of a single vacuum tube
PR1.1, PR1.2 - two halves of a single stereo potentiometer
So on the PCB I want it convert to one 9 pin tube socket and one stereo potentiometer with 6 one to one connections between them.

How can I make convert to 2 footprints instead of 4?

 
#PCB#
Circuit Design