Hi,
When i simulate my schematic, i have always this error message: The circuit has components without simulation model:GND
https://easyeda.com/editor#id=|448b08dc51894aafa9eb9f9d6bdb307b|eaf3fa0d0df340dc989843dcd661bda6
Thank
#Simulation#Hi all,
I need clarification about Graetz bridge because reading several books and web pages and doing a simulation in EasyEda I have different results.
I am starting a few projects on EasyEda just to test my old Electronic knowledge and start again an old passion.
I am trying to build a simple Power supply step by step to test my knowledge but also EasyEda.
I created this project for a 230V AC (50Hz):12V AC using a transformer of 0.053 ratios. So far so good. I have a 12.115V AC in output and almost 17 Vp and 34 Vpp. The load is a 10k Resistor.
https://easyeda.com/sasadangelo/transformer
In this other project, I added a Graetz Bridge and I expect to find my 17Vp dropped of 1.4V (due to two diode of the bridge). So I expect to have 17-1.4=15.6Vp (15,6*2=31,2Vpp) and then (15.6Vpp/1.41)=11.06.
https://easyeda.com/sasadangelo/powersupplywithcapacitor
From the simulation, I see Vp=16.3 and Vrms=11.49 in a multimeter.
Around the web and books I find three design approaches that bring to a different result:
1) Now, some books report that Vp=(12V-1.4)1.41 but I think THIS FORMULA IS WRONG because the voltage drop is applied to the sinusoidal wave, not the RMS one.
2) Other resources, report Vp=12V1.41-1.4=15.52V, and this value does not agree with EasyEda.
3) I found other resources like this:
https://electronics.stackexchange.com/questions/229381/output-voltage-calculation-for-full-wave-bridge-rectifier
that apply the 1.4 drops to Vpp instead of Vp and this kind of resource seems in agreement with EasyEda.
However, applying logic to me it seems that 2) should be the correct one. In fact, when a positive semi wave crosses the bridge it passes through two diodes, so the positive semi wave should have a drop of 1.4V, the same for the negative (while EasyEda according to 2 has only 0.7 drops). Can someone help me to understand why EasyEda and this resource are correct?
#Simulation#EasyEDA doesn't support muti-channel design yet, there are two methods
## 1. Use Module
Make sure your editor version is v6.4.3 and above
- New module placement, to support multiple chanel layout. How to work:
- Create new Schematic Module and PCB Module, corresponding the prefix
- Place module, enter the same identification English letters
- Continue placing the modules with different identification English letters
- When Schematic Modules quantity same as PCB module, do Import Changes, it will keep the PCB modules layout, and then impelement the multiple chanel layout
- The module can not exit un-annotated prefix, such as two U?
## 2. Use script
thanks to user elvisfox, he have provided a script can do this,
please refer at:
https://github.com/elvisfox/easyeda_multichannel
https://easyeda.com/forum/topic/Copy-Paste-Dublicating-9185827a952e4312854e808ed38df228









