BUG
Concise problem statement: My project has a single schematic, yet trying to convert it to PCB causes the error below (duplicate ref des, 3 schematics with same names). There are no duplicate schematics.
Fixes I have tried:
- cloned the original, deleted the original and tried with the clone - same error.
- re-annotate schematic to no avail.
- restarted the browser.
TBD:
Delete project, create new one, put schematic in there.
Link to project here: https://easyeda.com/FrankCA/Reflow_controller_v1_0-d495c82c6e9e4d6791221cd4a43f21c6
Browser: Chrome
#Bug Reports#BUG
Concise problem statement:
A project has three schematics and one PCB. When attempting to save one of the schematics, a popup declares "Network Error". The other two schematics and the PCB will save without issue when edited.
Link to project:
https://easyeda.com/tvoght/New_Project-8a046be709e9499084285c29fedf666b
Steps to reproduce bug:
-
Try to save schematic central_control in above link, whether modified or not.
Results:
Network Error popup
Expected results:
Successful save
Browser:
Google Chrome 58.0.3029.81 (64-bit) Linux
Hello all :)
I have made my first project that I want to order PCB for. But I don't know if it will work or if all looks OK.
If anybody have some time available it would be great if you could check out my project and see if all looks fine :)
https://easyeda.com/kjetil.nt/Dust_collector-1328b8bbde5e400494c293826cfeb580
What I am hoping this does;
-Talk to a control unit (in the future, but for now, just standalone) via I2C or other protocols.
-Input is 12 V, a transistor is used to get it down to 5V for the ATTINY 85.
-Current sensor should sense that when current is drawn the solenoid opens the gate and sends a signal to the dust collector to start.
-An remote switch that starts the dust collector manually if you don't use the current sensor.
-External 12V source if you use many gates and you don't want high current go throug the thin 4 lead wire.
Can this have a chance to work? :p Thank you if you speared some time to review my work :)
#General Discuss#Im about to order my first PCB and reading How to generate Gerbel files from Eagle right now. My question is, will the tNames and bNames be printed on the pcb? Because when i click on "Silk Bottom" and "Silk Top" tabs on Eagle these two, tNames and bNames are selected along with the usual tPlace and bPlace. Can I just un-select these two so they won't be printed?
#Skill#
