When I specify the hole size for a through-hole pad, is that the drill size or the finished size after through-hole plating? On https://easyeda.com/Doc/Tutorial/PCBLib.htm, it says "This is the drill hole diameter for a through hole pad." If it is the drill size, how much do I need to add to account for the plating to get to a desired finished size?
In https://www.speedingedge.com/PDF-Files/anatomy%20of%20a%20plated%20hole.pdf, 3 mils is suggested, but I don't know if this varies between manufacturers.
Sorry if this is answered somewhere, but I couldn't find it.
Thanks
Peter
#PCB#I have a design where I use 2 arduinos on 1 pcb. Some arduino pins are used
but some are not. The pins which are not used are automatically connected
in the pcb design, when the pins have the same name and or numbers.
Why is this and how can I make sure this isn't happening?
https://easyeda.com/PeterEmaldo/PC_led_control_master-d58ef3964172417bab2a0061d978d69f
#PCB#I ordered a PCB from EasyEDA in late 2016. The project is here: https://easyeda.com/TyeEasyEDA/Boomerang_Keyboard-a2d4e41a4fbf4da490f883c4b93fd55c .
As you can see, it has a large number of internal square cutouts for small RGB LEDs. The footprint for these LEDs was tested by another user who received samples that were perfect. His LEDs fit the square cutout perfectly and the internal radius was very sharp and tight.
When I received my PCB, the LEDs do not fit without extensive filing because the corners are too rounded.
Before I order v2.0, is there a way to designate a smaller drill bit or radius like the original samples had?
#General Discuss#