BUG

Concise problem statement: On some occasions, especially after replacing components, the ratlines will show up as if the pads or the nets were not properly connected. I need to save, close the pcb and reopen and the ratlines are gone.

Steps to reproduce bug:

  1. Place a component to a PCB and connect the pads to the circuit. Place a new component over top and give the pads the same net names as the underneath component.

  2. Delete the underlaying component and sometimes, ratlines will appear.

  3. I need to save my PCB and close it. When I reopen, the ratlines are gone.

Expected results: Ratlines should be present only when pads are not properly connected to their respective nets.

Browser: IE11

#Bug Reports#
#BugReports#
Bug Reports

No comments yet. Be the first to comment!