So it is my first schematic and I'm trying to run it.

Here's the schematic:
https://easyeda.com/djays12/Tachometer_electronics-076dcb60fc8f48358604c85fbfbcc000

I've already replaced the NPN transistor (it used to be a BCW66G) for a generic model that can be read by spice.

Mainly the circuit is a frequency/voltage converter that will be used to convert a 0-267Hz square wave signal into a 0-1.6Vdc voltage. The output of the LM2907 is then boosted through a op amp and a transistor to be able to output enough current for the load (an electromagnet, that I replaced by a inductor in the circuit).

This circuit will be used to power a tachometer (the electromagnet is acting on the needle and fight again a return spring).

The message error I get is as follow:

Circuit: gooduntitled

Doing analysis at TEMP = 27.000000 and TNOM = 27.000000

Warning: v2: no DC value, transient time 0 value used Warning:
singular matrix: check nodes u1_2 and u1_2

Note: Starting dynamic gmin stepping Note: One successful gmin step
Note: One successful gmin step Note: One successful gmin step Note:
One successful gmin step Note: One successful gmin step Note: One
successful gmin step Note: One successful gmin step Note: One
successful gmin step Note: One successful gmin step Note: One
successful gmin step Note: One successful gmin step Warning: singular
matrix: check nodes u1_2 and u1_2

Warning: Dynamic gmin stepping failed Note: Starting source stepping
Warning: singular matrix: check nodes u1_2 and u1_2

Note: One successful gmin step Note: One successful gmin step Note:
One successful gmin step Note: One successful gmin step Note: One
successful gmin step Note: One successful gmin step Note: One
successful gmin step Note: One successful gmin step Note: One
successful gmin step Note: One successful gmin step Note: One
successful gmin step Note: One successful source step Warning:
singular matrix: check nodes u1_2 and u1_2

Warning: singular matrix: check nodes u1_2 and u1_2

Warning: source stepping failed

DC solution failed -

Last Node Voltages

Node Last Voltage Previous Iter
---- ------------ ------------- xr2_2 0 0 r1_1 0 0 u1_1 0 0 v1_1 0 5.8766e-118 r1_2 0 0 u2_6 -1.52529e-103 -1.38638e-117 volprobe1 5.35177e-104 7.98716e-118 l1_1 5.35177e-104 0 u1_2 0 0 l1#branch 0 0 v1#branch 2.51539e-115 0 v2#branch 0 0

doAnalyses: iteration limit reached

op simulation(s) aborted Error(parse.c--checkvalid): volprobe1: no
such vector. ngspice-26 done

Anyone have an idea on what I did wrong?

#Simulation#
#branch00v1#
#Simulation#
Circuit Design

No comments yet. Be the first to comment!