BUG

If I have a multi-sheet project with a Net Port with the same name on multiple sheets, in the Design > Nets they show up as having no connections --- that is, they get a red (X). This should only happen if a Net Port has no corresponding (i.e., like named) Net Port on any other sheets in the project.

Steps to reproduce bug:

  1. Make a 2-sheet project.

  2. Put a resistor on both sheets, connect one end of each resistor to ground, and connect the other end to a Net Port named "A".

Results: They will correctly be connected on the PC Board, but Design > Nets shows them both with a red (X).

Expected results: Green check.

Browser: Chrome, but likely unimportant.

#Bug Reports#
#BugReports#
Bug Reports

No comments yet. Be the first to comment!