I get the following warning when I attempt to apply a general copper fill to the entire board, exclusive of tracks:

Warning
EasyEDA does not allow inner board outlines cutout. Please use SolidRegin or HOLE.

That is exactly how it appears, including the misspelled word ( I'm pretty sure it's meant to say "solid region"),

but I don't know what it means, or how to fix the issue. I am not even sure if I'm asking for outlines to be cut out.

Using a solid region instead of copper area obliterates all tracks, so no.

I could apparently fix the problem with a hole, but it is not obvious to me where the hole should be placed.

I was actually trying to avoid holes other than the ones for the pinheader.

Any solution for this available?

Thank you in advance for your time and expertise.

Thermas

#PCB#
#PCB#
Circuit Design

No comments yet. Be the first to comment!