I have a switch that is a dP3T slide, and the two poles come from a BNC.  When i examine the PCB, i see connections that don't match the schematic they came from.   How can that be?  I am so close of having these made, but I am  very careful to examine everything, but now I can't trust what the autorouter is doing.

Here is the board   https://easyeda.com/joe.massimino/20db-attenuator

So I looked at the schematic  and it is correct, so I ran it to a new PCB and what I think is going on, is the pins on the switch are misplaced.   So I'm trying to figure out the next step.

So after looking at other parts that resembled the same switch, none had the same perfect measurements as what I have now.  So my only recourse is to wired the board myself, is disregard using autoroute.

Update:  I can't create a PCB with just parts, it will not allow it.  So what I  need is to get a properly wired DP3T switch , and none come up in the library when I search. Maybe  someone has one that they can give me, or  I will have to edit the switch I have.

#PCB#
#PCB#
Circuit Design

No comments yet. Be the first to comment!