New to easyeda, and I've not been able to figure out the best way to handle socket-able items (fuse holders, IC-chips with DIP sockets, etc.), so that the component (fuse, IC) AND the socket (fuse holder, DIP sockets) both appear in the BOM.

Do I put both the fuse AND fuse-holder in the schematic, but set the actual fuse to Mounted=NO (thus not appearing in the PCB)?  However, when I looked at how Mounted is to be used, it didn't seem to fit this scenario.

What's the best approach here?

#Skill#
#Skill#
Circuit Design

No comments yet. Be the first to comment!