So - targeting 4 layer board -- Out signal layers, in 2 are vcc and gnd.

So, I declared them in them in the layer manager and defined them as 'vcc' and 'gnd'

When I look at a component with vcc and gnd  nets,     I think I see the connection with thermals for the GND pins (through hole), on BOTH VCC and GND

Has anyone else tried doing this. ?   or do you manually have to tie each pin in to the net.    It appears to me that it only supports a GND Plane,   NOT a vcc plane ?   Am I correct ?

#PCB#
#PCB#
Circuit Design

No comments yet. Be the first to comment!