Very new to EasyEDA & nspice.  I have been reading the tutorials.  Any guidance would be appreciated.

Just trying a simple OP Amp LF356N,  which I got out of the library/SCH libs/system

I finally got the simulations to run without an error, but the output pin (and the - input pin) don't register an output on any of the simulations (transient, AC analysis, DC sweep etc.

I see on the simulation plots the Sin wave of the AC source, but not on Volprobe 1, which should have a gain of about 3.3

Do I have to make up the OP Amp and insert the spice code?

here is the project, again any guidance would be appreciated.

Active file's owner project page
https://easyeda.com/phillman5/shared-simple-op-amp

Active project editor page
https://easyeda.com/editor#id=|f79a39fbeeb847c1bc9e1043b6d327d0

Thanks in advance!

#Simulation#
#Simulation#
Circuit Design

No comments yet. Be the first to comment!