This is PROBABLABLY a operator error but I can't figure it out.

I have a small 4 layer PCB design, with plane on inner 1 and inner 2.   all signals are on top and bottom.

in EASYEDA,  LAYER MANAGER inner1 and inner 2 are Check and type as PLANE
                        on the LAYER and OBJECTS -- I see both, INNER1 and INNER2
                        When I look directly at the layers, I see the correct "thermal" connections.
                        When I do GENERATE GERBERS- is says 4 LAYERS
BUT when I get to the JLCPCB Order
                         It initially says 4 layers
                         then loads GERBER file goes to 2 layers
                         If I load a stored Gerber file (of the same design) it also says 2  layers

SO,  some how when I generate Gerbers it is ONLY doing 2 layers !!! Why ????

#Bug Reports#
#BugReports#
Bug Reports

No comments yet. Be the first to comment!