How to add a capped via to a PCB layout?
Hi all,
I'm designing a new PCB layout which will be quite tight. I would like to use via in pads to simplify my design. To do this without the solder going through the hole I would use copper capped vias, also called blind vias, which now seem to be a quite common design practice.
How could I do this in EasyEda?
Regards,
Jean-Michel Gonet
EDIT: I've changed the category of the post to JLCPCB, as suggested by Andy

PCB
Sign In Or Register Comment after
No comments yet. Be the first to comment!