Two PTH in oval pad, one hole oval, is this acceptable?
Hello,
I'm trying to design a PCB on which I would like to have two plated through-holes, one of them being oval, sitting on the same pad (or at least connected by a trace). Is such design acceptable, following JLCPCB's capabilities?
I noticed this thread: Oval pad with two holes, which gave me some answers, and I also checked JLCPCB's capabilities, but I am still unclear whether the dimensions I am using are acceptable...
I would really appreciate getting your input on this. Here it is in "resources": OVALPAD2HOLES, and this is what it looks like:

Thanks in advance for your very precious help.
Update: I learned that I can edit a post, but I cannot edit/delete a reply. So I'll put the additional info here too:
I noticed this rule in JLCPCB's capabilities:
The minimum plated slot width is 0.65mm, which is drawn with a pad.
The slot in the screenshot above was only 0.6mm wide, so I increased it, as well as the round hole diameter, to 0.65mm.
I kept both annular rings to 0.4mm, so the two holes are still 0.8mm apart.
You can check the updated OVALPAD2HOLES resource.

Sign In Or Register Comment after
No comments yet. Be the first to comment!