I would appreciate any advice how to improve PCB design to achieve the highest sensitivity for the GPS signal. The design is based on S76G chip.

The tracker will be sewn or encapsulated in plastic into cat collar together with two dipole wire antennas (GPS 9.04 cm, LORA 8.20 cm, lambda/2 & lambda/4 - 5%) and fine tuned by NanoVNA.

I am not sure if I should include GND pads for both antennas to signal via shielding (GPS & LORA) and make separate grounds for digital, GPS and LORA signals, connected in one place only. The PCB is 27 x 12 mm four layers: VF signal/GND, VF GND, Power lines, Digital signals/GND. The CPWG is designed to 50 Ohms (189/90/100/4.05 w/space/er height [um]/er).

X1 is MEMS LSE 32.768kHz oscillator, X2 TCVCXO 26MHz and U2 is LDO 1.8V

image

Very first PCB design, see antennas:
Very first PCB design, see antennas




#PCB#
#PCB#
Circuit Design

No comments yet. Be the first to comment!