I would like to suggest to add a separate clearance setting under 'Hole Properties'.
If i use the PCB Tool the clearence to a copper plane is set by the general clearance which in many cases is to small
if you are using washer and nuts which could lead to a short.when assembling the pcb to a case.

Right now i use custom symbol and footprint with NoSolid copper areas included as discussed in the pcb layout section of the forum.
Example:
https://easyeda.com/tubes3000/forum_example
Thanks,
Olaf

#Feature Requests#
#FeatureRequests#
Feature Requests

No comments yet. Be the first to comment!