The recommended footprints for RF devices usually include a large number of ground vias (to reduce inductance)\, and large-area ground areas carefully placed at specific locations and distances from the pin pads.  However\, most of this ground *must* be covered with soldermask so the pin pads will correctly hold solder paste.  One very much wants this ground layout to be part of the footprint\, because re-drawing it every time the part is used is quite laborious and prone to accidentally making the edges of the ground a few mils off where they are supposed to be.  What is the best method for drawing these pre-defined ground solid shapes?  When I tried them in EASYEDA as shown for this four-pin part (which has two pins grounded\, and an input and output pin)\, I get a hundred DRC errors because there is no way to assign the metal ground areas to be net GND.  Thank you.

image.png

#PCB#
#PCB#
Circuit Design

No comments yet. Be the first to comment!