Is there a minimum PCB dimension (non-SMT) for V-Cut panelization?  I recently submitted a small rectangular PCB (10mm x 22mm) that I panelized (in EASYEDA) for V-cut (5 columns, 3 rows).  After submitting (and paying), I got this message:

An additional charge is applied to Y98-2263294A
2021-02-18 23:59:43
1.The size for your pcb is too small( less than 15mm per side), it will take a very long time and have much more difficulties to carry out the v-cut process.

The total board (panelized) was 50mm x 66mm.  I wasn't aware that there were any minimum sizes for V-Cuts.  Any insight into what I may have done wrong here?

BTW:  the original order (above) is in-production (after a few rounds of correspondence and selecting "panelized by JLCPCB").  I'm really just asking what I should have done differently to avoid this in the future.  I really would like to be able to "panelize by customer".

#PCB#
#PCB#
PCB

No comments yet. Be the first to comment!