I have a board with three LCSC part C95463 3.5mm TRS jacks connected in parallel (T to T to T, R to R to R, etc.):
image.png

The jack is build such that T, R, and S each come out on two pins, for mechanical stability, but internally they are electrically connected together by a metal strap that spans across the top of the connector:
image.png
So I don't need to connect the two "T" pins together, or the two "R" pins, or the two "S" pins.

But, the way the footprint exists in the library, if I don't connect the two corresponding pins together, I get unrouted ratlines, and DRM tells me there are orphaned nets:
image.png

How can I tell the software that these pins are connected internally? I would think the footprint already has this covered:
image.png
Yes, I could work around, but I'm looking for the "right" way to fix this, so workaround suggestions aren't needed.

Thanks!

...R

#PCB#
#PCB#
Circuit Design

No comments yet. Be the first to comment!