In the past I had a project where the 230V paths had to handle 10A, for this I didn't have better idea than to use the biggest width fit on my schematic (5mm) and make it double sided and connected with VIAs to give a double surface area.

Then at manufacturing I have used the Outer Copper Weight 2oz for max copper area.

Even then when an 1100W load was connected I could feel the device getting hot and if you calculate that:

I=P/U=1100W/230V=4.7A

It is only half of the planned capacity so on 10A this thing couldve burn I never tried.

I'm designing another DC system which has to carry max 10A@12V through some lanes. Of course I could just add additional regular copper wires between the points and it would easily handle that but then what's the point of manufacturing a board I can just protoboard it.



Is there any future for the board making which can produce strong paths like this on the picture:
high

#PCB#
#PCB#
Circuit Design

No comments yet. Be the first to comment!