Hi,

Never done a ground plane before so I would like to get feedback as to whether my approach is correct.

Please refer to this very simple schematic and PCB layout:  https://oshwlab.com/jalsop/ground-plane-test



I did the following:

1.  Positioned the through hole components

2.  Routed the non-GND tracks manually, including a via and a track on the bottom layer.

3.  Added a copper area assigned to GND and placed it on the bottom layer

This seems to have successfully made all the GND connections.

Could someone take a quick look at the PCB 3D view and advise if everything is ok.

I am not totally clear on how the +5V pin on the power jack avoids being shorted
to the ground plane.  I'm guessing there is a small ring of copper around the pin, and
then a blank area separating it from the ground plane?  Its hard to tell so I would
appreciate learning from others who have already done this.

Thanks in advance for any feedback!












#PCB#
#PCB#
Circuit Design

No comments yet. Be the first to comment!