Hi!

I added a potentiometer to my schematic.  I think the rat lines are showing incorrectly.

Here's the section of the schematic
image.png
Here's how the rat lines look on the PCB
image.png
There are a couple of problems:
1. The rat lines show that the wiper and the other pot terminal should be connected to the same op amp pin (unlike in the schematic\, where the wiper connects to a 220k resistor).
2. The rat lines indicate that the op amp pin should connect to the +ve terminal of the electrolytic capacitor (which it already does).

The footprint of the pot is TRIMPOT-PTH-3386U.  I've tried dragging the schematic component of that around in the Footprint Manager, just to check it's been drawn correctly
image.png
The same thing happens if I use a different potentiometer (POTENTIOMETERS_PADS_SMALL).

A very similar thing happened when I inserted a three pin header between two diodes which were previously in series.
image.png
The rat lines do something odd, and the existing nets seems to be broken
image.png

By the way, huge thanks for continuing to provide and support this awesome tool.

Kind regards,
Bill

#PCB#
#PCB#
Circuit Design

No comments yet. Be the first to comment!