Preventing pin and mounting holes from going all the way through the board
I'm an electronics noob so sorry if this is a dumb question.
I am designing a very simple bipolar EMG probe. It consists of three copper electrodes on the bottom, each wired to a 3.5mm headphone jack on top. I'm planning to connect it to an off-the-shelf EMG amp like the Grove EMG detector or the OYMotion Gravity EMG sensor. Here's a picture:

As you can see, the headphone jack's mounting holes go all the way through the entire board including the electrodes, reducing their contact area. The headphone jack (PJ-621C) has extremely tiny pins that do not extend below the component body so I don't see why it needs to penetrate 3 whole layers of fiberglass on this 4-layer board.
Is it possible to stop drilling the holes before reaching the bottom layer? Even better, would that be possible on a 2-layer board with only a single sheet of fiberglass? I did find this post about vias that said only through-holes were supported and blind vias were not, but that was only about vias and it's a 5-year-old post.
Thank you
#PCB#
Sign In Or Register Comment after
No comments yet. Be the first to comment!