Requesting a second set of eyes for my ATOM sensor "Hat" Circuit to PCB
While not my first board it is only my 3rd and the 2nd was a reprint of my first because I made a stupid mistake. So learning from my mistakes I thought I would ask for some extra eyes to make sure I didn't miss anything obvious.
This is, I think, pretty straight forward. I have a number of Atom M5 Lites laying around and I wanted to create a nice package that would allow me to measure T&H for my Home Assistant. With that in mind I designed the PCB.
I picked the Capacitor and resistor and LED based on what were "Basic" parts so hopefully I didn't make any crazy mistakes.
Since the ATOM is based off of the ESP32 and that's a 3.3V logic chip I hope I'm safe in leaving off the voltage shifter. I didn't see anything on the SHT40 which indicated that it drew more than the 100mA that the 3.3V pin on the ATOM can provide.
The link to my project https://oshwlab.com/quickstar77/m5sensorshield
One of my concerns is if having pins connected to the GPIOs that I'm not using will cause issues. Should I attach them to ground or maybe a resistor?


SHT40
ATOM Lite M5stack
Capacitor
Resistor
LED
Sign In Or Register Comment after
No comments yet. Be the first to comment!