Hello everyone,

I am encountering an issue while attempting to position the SMD round nut from LCSC on my board (also available in the JLCPCB library):  https://www.lcsc.com/product-detail/SMD-round-nut_Sinhoo-SMTWE2015MTJ_C2928176.html The design rule check (DRC) indicates a requirement of 0.152mm, whereas the nut's polygons have a solder mask of 0.050mm.

I attempted to amend the Design Rules for the nuts to a clearance of 0.05mm, which unfortunately didn’t rectify the issue. I'm uncertain if this adjustment is correct.

I seek guidance on how to resolve this, and understanding the root cause. Could there be a mistake on my part in utilizing these nuts?

Project URL: https://oshwlab.com/logronoide/solderless-raspberry-pi-pico



Warm regards.

#PCB#
#PCB#
Circuit Design

No comments yet. Be the first to comment!