Hi guys,

I'm designing a pcb which should have 4 (later 8) exactly the same units on it, together with some other stuff.
To accomplish this I was thinking about using modules and this is what I did:

First I created a whole new project for it (https://easyeda.com/mijnmodelbaan/lightning_02_copy)
Then I created a schematic and a pcb from that schematic.
Routed a few tracks by hand, used the local autorouter for the majority of the tracks and after routing the last tracks by hand, I was finished.
Well, that is to say, after routing the last few tracks by hand and correcting the DRC errors it was finished.
Then I saved the schematic as a schematic module and the pcb as a pcb module and started a new project (https://easyeda.com/mijnmodelbaan/module_testing).

In this project I created 2 sheets and on both sheets I put the schematic modules I created earlier.
For the first one I used the letters 'QQ', for the second one I used 'AA'.
After doing this I noticed the components were all renamed with the chosen letters (QQ, AA) in front of the original names.
Screenshot 2020-11-09 172426.png
But of the Nets only a few were renamed, 16 of the 49, and the ones not renamed pointed to both sheets.
Screenshot 2020-11-09 172612.png  Screenshot 2020-11-09 214021.png
This is not what I expected.

I created an empty pcb (just to see what would happen) and put 2 pcb modules on it (the ones I created earlier).
Here the same problem arised: after importing the changes only 16 of the 49 Nets were ok.
Screenshot 2020-11-09 173628.png

Please let me know what I did wrong so I can solve this, preferably in a simple way.

Thanks for your time.

#Schematic#
#Schematic#
Circuit Design

No comments yet. Be the first to comment!