(“Version : V2.1.49.573a4102.674264 BuiltDate : 2024-01-30”)

 

I am having difficulty with EasyEDA-PRO in Half Offline mode. Hoping that someone will point out with what settings I need to correct, or if you are seeing the same issues.

 

The planned PCB is a 2 layer board.

 

In particular the DRC is detecting spacing failures after autorouting (internal EasyEDA, or Freerouting), even with what I think the correct parameters have been applied. Should the autorouting layout not provide appropriate spacing between traces, vias, pads etc, or do I need to move stuff by hand afterwards? I realize I will need to re-route certain traces etc, however has anyone seen similar results like what I am seeing below? Thanks.

 

[I was also getting DRC spacing errors for pad spacing on a Micro-USB connector (C2972784), however that error has somehow disappeared today... with no apparant changes applied to the settings]

 

Here is an example with results of Freerouting autorouter (similar results for EasyEDA autorouter):

 

 

You can see from the above, that vias are placed too close to trace, traces routed too close to component pads or slots.

 

Here are the PCB layout parameters:

The following is the DRC Rules (I modified to match JLCPCB capabilities for 2 Layer PCB)

 

Safe Clearance Design Rules settings:

 

 

The above settings were selected based on JLCPCB Capabilities for 2 Layer PCB. See JLCPCB capabilities: https://jlcpcb.com/capabilities/pcb-capabilities

 

 

 

 

Track Physics Design Rules settings:

 

 

Via Size Physics Design Rules settings:

 

 

 

 

 

 

 

#PCB#
#PCB#
Circuit Design

No comments yet. Be the first to comment!